高雄科技大学フロンティア金属成形研究開発センター（台湾）と岐阜大学地域連携スマート金型技術研究センターをつないだハイブリッド型「第１回合同ゼミ」を開催し、国際交流を進めた。

 

 

OKB岐阜大学プラザで各大学3名の教員から研究紹介と質疑応答を行い、積極的な議論が活発に行われた。紹介された研究分野はスマート金型やデジタルツイン・３Ｄプリンタを活用したラピッドプロトタイプなどがある。

 

２０１９年１２月２７日に連携協定を締結したが、その後コロナ禍によって、具体的な交流が進んでいなかった。この第１回合同セミナーを期に今後、学生・教員の交流を積極的に進めていくことに合意した。

 

以下は実施プログラム。

 

Chairpersons: Prof. Yoshinori Yoshida (Gifu University) and Prof. Bor-Tsuen Lin (National Kaohsiung University of Science and Technology)

 

9:00-9:10: Greetings from President Kazuhiro Yoshida (Gifu University).

9:10-9:50: Professor Bor-Tsuen Lin (National Kaohsiung University of Science and Technology) introduces the Frontier Metal Forming Research and Development Center National Kaohsiung University of Science & Technology and “Prediction and Verification of Servo Punch Forming Curve”.

 

9:50-10:30: Professor Yoshinori Yoshida (Gifu University) introduces the Center for Advanced Die Engineering and Technology (G-CADET) Gifu University and “Automatic optimization of shearing process condition by autopilot finite element analysis with optimization algorithm based on machine learning”.

 

10:30-11:00: Prof. Tung-Kuan Liu (National Kaohsiung University of Science and Technology), “Adaptive Dynamic Scheduling Systems for Smart Manufacturing”.

 

11:00-11:30: Professor Hiroyuki Kousaka (Gifu University) introduces the Center for Applied Research of Plasma (c-ARP), Faculty of engineering, Gifu University and “Plasma assisted lubrication by dielectric barrier discharge in ball-on-disk type friction tester”.

 

11:30-12:00: Professor Jui-Hung Cheng (National Kaohsiung University of Science and Technology), “Innovative Engineering Design and Sharing of Industrial Practical Experience, Bridging Innovation and Expertise: A Synergistic Approach to Engineering Excellence through Design Innovation and Practical Experience”.

 

12:00-12:05: Mid Term closing, Vice President Prof. Zhigang Wang (Gifu University).

 

12:05-13:00: Lunch break

 

13:00-13:30: Professor Minoru Yamashita (Gifu University), “Joining of Metal Plates at Edges by High-Speed Sliding with Compression”.

 

13:30-14:00: Free discussion about future activities

 

14:00-14:10: Closing remarks, Professor Yoshinori Yoshida the Director of Center for Advanced Die Engineering and Technology (G-CADET) (Gifu University) .

 

14:10-15:00: Campus tour.